How do you fish wires through a ceiling?

Reel and wind the fish tape, which will pull the electrical wire along with it as it snakes through the wall and ceiling. Grab the wire as it emerges from the hole. Pull an additional 2 to 3 feet free.Click to see full answer. In this regard, how do you hide wires on ceiling? Measure. Measure the wall to determine the length of the cords you want to cover. Cut. Cut the base and cord cover to match the length you just measured. Mark anchor points. Use a pencil to mark the anchor points on the wall. Mount base. Lay the cables. Paint. Use cable ties. Conceal with flex tubing. Additionally, can you run wire behind studs? Yes, you can run the cable behind the studs. In these situations, you often see the electrician only drill a hole in every other stud and run behind the stud between. You can also afford to offset the drilled holes towards the back of the stud to get them even farther from possible damage from nails. Just so, what happens if I drill through a wire? If you suspect that an electric cable has been hit, it is absolutely necessary to repair it. You should immediately ensure that the power is switched off before touching anything. In the worst case, if the protective earth conductor has been damaged you otherwise run the risk of a fatal electric shock.How do I know where the wires are in my wall? Before drilling, find out exactly where the wiring is. Place the stud finder with wire tracing mode onto the wall. Move the finder along the wall, front towards you and the flat side against the wall. Move the stud finder over the electrical wires.

ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZp2iq5hixKq%2BxKxkraCipMKotIyaZJydmaG2r7OO